
5
SYMPTOM
There is no spark when lighting the
gas.
The gas ring burns unevenly.
SOLUTION
Check that the unit is plugged in and the
electrical supply is switched on.
Check that the RCCB has not tripped (if
fitted).
Check the mains fuse has not blown.
Check the burner cap and crown have
been placed correctly, e.g. after cleaning.
Check the main jet is not blocked and the
burner crown is clear of food particles.
Check the burner cap and crown have
been placed correctly, e.g. after cleaning.
Something not working
If the appliance is not working correctly, please carry out the following checks, before contacting
your local Service Force Centre.
IMPORTANT:
If you call out an engineer to a fault listed below, or to repair a fault caused by
incorrect use or installation, a charge will be made even if the appliance is under guarantee.
Maintenance
and Cleaning
Before any maintenance or cleaning
can be carried out, you must
DISCONNECT the hob from the
electricity supply.
The hob is best cleaned whilst it is
still warm, as spillage can be
removed more easily than if it is left
to cool.
The Hob Top
Regularly wipe over the hob top using a soft
cloth well wrung out in warm water to which
a little washing up liquid has been added.
Avoid the use of the following:
- household detergent and bleaches;
- impregnated pads unsuitable for non-
stick saucepans;
- steel wool pads;
- bath/sink stain removers.
Should the hob top become heavily soiled,
it is recommended that a cleaning product
such as Hob Brite or Bar Keepers Friend is
used.
Pan Supports
The pan supports are dishwasher proof. If
washing them by hand, take care when drying
them as the enamelling process occasionally
leaves rough edges. If necessay, remove
stubborn stains using a paste cleaner.
Ignition candle
The electric ignition is obtained through a
ceramic "candle" and a metal electrode (fig.
1, letter C). Keep these components well
clean, to avoid difficult lighting, and check that
the burner crown holes are not obstructed.
The Burners
The burner caps and crowns can be removed
for cleaning. Wash the burner caps and
crowns using hot soapy water, and remove
marks with a mild paste cleaner. A well
moistened soap impregnated steel wool pad
can be used with caution, if the marks are
particularly difficult to remove. After cleaning,
be sure to wipe dry with a soft cloth.
Kommentare zu diesen Handbüchern